Manufacturer of Conveyor Belt Repair Strips Analyzes Techniques for Purchasing Repair Strips

The ultimate purpose of purchasing repair strips from conveyor belt manufacturers is to bond the wound area of the conveyor belt, prevent the wound from expanding, and minimize potential hazards on the conveyor site. This requires the selected repair strip to have strong adhesive properties. 
At present, the commonly used repair strips on the market are ordinary repair strips and CN layer repair strips. Of course, in terms of adhesive strength, the adhesive strength of CN layer repair strips can reach more than three times that of ordinary repair strips, and the usage rate is relatively higher. In order to better ensure the bonding effect after repair, manufacturers tend to choose imported repair strips with CN layer. CVUL with CN layer repair strip is a typical representative. 
The CVUL repair strip has a blue CN semi vulcanized layer on the adhesive surface, which can form a chemical cross-linking reaction with cold vulcanized adhesive. The adhesive is fused to the adhesive surface of the repair strip, further enhancing the adhesion between the strip and the conveyor belt on the basis of the original adhesion force. 
The important reason why manufacturers choose repair strips for adhesive repair of conveyor belts is not only to ensure the bonding effect, but also because the repair strips are easy and fast to operate, which can greatly reduce downtime and improve construction efficiency. This requires a variety of repair strip specifications, and various damages can be directly attached. 
There are various specifications available for CVUL repair strips based on the degree of damage to the conveyor belt and on-site requirements. 
Repair strip without fabric reinforcement layer specification (thickness * width * length)
2.2*100*10000mm；3.2*150*10000mm； 3.2*220*10000mm，3.4*300*10000mm； 3.4*400*10000mm
Specification for reinforcing layer of repair strip fabric (thickness * width * length)
3.6*100*10000mm；4.6*150*10000mm； 4.6*220*10000mm；4.8*300*10000mm； 4.8*400*10000mm
In order to prevent the occurrence of slipping and deviation during the operation of the conveyor belt after repair, it is required that the surface of the conveyor belt has super strong anti slip and wear-resistant properties. Of course, the repair strip attached to the surface of the conveyor belt also needs to have anti slip and wear-resistant properties.